HumiSeal® Stripper 1080 can be used to remove cured HumiSeal® acrylic coatings without negatively affecting printed wiring board substrates or components. HumiSeal® Stripper 1080 contains no ozone depleting chemicals and meets North American air quality regulations. HumiSeal® Stripper 1080 is in full compliance with the RoHS Directive 2002/95/EC.
HumiSeal® Stripper 1080 is safe for use on epoxy markings, epoxy substrates, solder, copper, silver, gold and nickel plating. It will swell or dissolve polystyrene and vinyl.
Immerse the component or printed circuit board assembly into HumiSeal® Stripper 1080. The rate at which the existing coating will dissolve will depend upon its thickness and age. A cured acrylic coating of normal thickness should be completely dissolved within 30 minutes at room temperature. Use of additional heat is not required. Keep the container covered to prevent solvent evaporation.
After the existing coating has been removed, thoroughly wash the assembly in isopropyl alcohol, deionized water or other qualified cleaning process. Oven dry the assembly for a minimum of 30 minutes at 66°C prior to recoating.
HumiSeal® Stripper 1080 is flammable and the following standard safety precautions should be observed:
|Compatible HumiSeal® Coatings||HumiSeal® Solvent Based Acrylics|
|Relative Evaporating Rate (BuAc=1)||1.0|
|Specific Gravity||1.3 ± .02|
|Flash Point (°C) TCC||21.7|
|Shelf Life, DOM||18 months|
|Colour||Clear to Reddish|
All values contained herein are typical values.
Please consult the Technical Data Sheet for the specific product to obtain complete information and detailed specification ranges and physical properties
We understand this and have created an intuitive Product Selector Guide to help you through the specification process.